Adyen - Installing a new PinPad

Once you have received your device from Adyen it will need to be paired with MYPOS before it can be used, before we can do this you will need to follow the below steps on the device

Step One
Ensure that the Adyen terminal is connected to the correct Wi-Fi Network To get the terminals online on the correct Wi-Fi Network, you need to:

• Press the yellow <

• Press 159

• Enter PIN and green O

• Select Network

• Select 2 Wi-Fi

• Search for The correct Network

• Enter the WiFi password
 

Step Two
Disable the Cellular function on the Adyen terminal, to do this:

• Press the yellow <

• Press 159

• Enter PIN and green O

• Select Network

• Select 4 Cellular

• Select 1 to turn off

Turning off the Cellular can take up to a minute to complete.

Step Three
Remove any other Wi-Fi networks from the device, to do this, you need to:

• Press the yellow <

• Press 159

• Enter PIN and green O

• Select Network

• Select 2 Wi-Fi

• Search for any other networks – there should just be the network you are connected to

• Enter the number of the other network (e.g. 3 MD100) 

• Select 4 Remove.

 

Step Four
You will then need to fix the IP address on the Adyen terminal, to do this:

• Press the yellow <

• Press 159

• Enter PIN and green O

• Select Network

• Select 2 Wi-Fi

• Select the correct WiFi network

• Select 2 IP Settings

• Untick the DHCP box <<< this can be tricky to un-select as it’s small

• Scroll down the screen, select Apply

Step Five
Once you have completed the above steps, you will need to take a photo of the QR Code on the PinPad, to do this press '5' and 'Green' and select the 'QR Code' icon in the bottom left hand corner

Please send the QR Code Photo to [email protected] they will then pair the device with MYPOS and advise you if there is any further steps required before the terminal can be used

‍